Joint & Several Liability in NC (law note)

British pennies & poundsIf a client has been sued, he wants to know how much is at risk if he loses at trial.  This is especially true where more than one person or company have been sued.  How is any damage award apportioned?

 The answer is not one clients generally like to hear:  your company can be on the hook for 100% of any damages.  This is true even if your company is really only liable for a tiny fraction of what caused the damages in the first place.  You can thank “joint and several liability” for that.

—————————-

For example, in a fairly typical construction dispute, an owner sues a contractor and the architect for construction defects. The contractor uses unsuitable substitutions, and the architect approves the unsuitable substitutes.   Both contractor and architect may be held liable for the resulting damages.  If a jury awards the owner $500,000, then both contractor and architect are liable for the entire $500,000 to owner.  That’s the “severability” part of the law.  As between the two, of course, they both share in the damages, and if the owner executes on the entire judgment against the architect (perhaps due to the architect’s insurance coverage), the architect can then go after the contractor for an equal share and get paid back $250,000 in “contribution.”  (That’s the “joint” nature of such an award).  This is, however, assuming the contractor has those funds.  Essentially, whoever has the funds when a judgment hits might end up paying for the entire award.  If the contractor doesn’t have $250,000 for the architect to be paid back, the architect is out of luck.

Does the result change if the jury finds the architect was only 5% liable for the damages and 95% were attributed to the contractor? Nope.  In North Carolina, where the parties’ actions together contribute to one indivisible injury, there is no apportionment.  “In for a penny, in for a pound” as the old saying goes.

Exceptions to the Rule?

Are there exceptions? But of course!  If the owner is also negligent, he can get no recovery at all since North Carolina is a pure contributory negligence state.  If one party is actively negligent and one passive, than the passively negligent party can seek indemnity from the active party.  If one party settles before trial, things become more complicated.  More on these subjects in future posts.  I’m also told that in other states apportionment is more the rule, so you may have better luck with your out of state projects in a similar situation.

As a general rule of thumb, however, for your North Carolina project, just assume that the entire amount of claimed damages may be presented to you for payment.  Unfair? Many times, yes.   That’s the nature of the beast.  It is also one of many, many good reasons to make sure you are doing business with people you trust and, more importantly, that other professionals are appropriately insured or bonded on any project you are working on.

If you have any questions about joint and several liability, drop me a line or a comment below.

 ______________________

Photo “Shiny pennies” by David Pillbro (Flickr Creative Commons license)

 

5 thoughts on “Joint & Several Liability in NC (law note)

  1. Betty says:

    We just built a new home and during construction we begged the builder to replace the plumber, as there were leaks and presure problems. Finally at the finishing stages, he replaced the plubmer, but it was too late becuase all the damage was covered by walls, 4 months after we moved in we found a leak in a tiled shower / exterior wall that has cause several thousands in damages and we had to leave becuase the levels of penicillium & aspergillus were off the charts! They provided a place for us to stay and we are painfully getting them to replace some of the water damage materials (sheathing, subflooring, plates, & joist – I am concerned of the stimga that this contamination and water damage has in my home and how the valve will decrease becuase of the plumber shoddy work. Any suggestions?

    • MelissaBrumback says:

      Betty:

      Thanks for your email. It is good that the builder is acknowledging responsibility and paying for corrective work. The issue you would have is proving the actual decreased value due to the stigma of the property. Proving actual damages is one part art, and one part science, but the “soft damages” such as property value/marketability can be hard to prove. You do have a right to those damages, but having that right and proving it in court are two different matters. One option would be to determine what amount of money you think is fair to compensate you, and demand that of the builder in exchange for a settlement & release. He may or may not agree to such a settlement. It likely wouldn’t be on the true value of what you might get in court, but it would be a sure thing versus something speculative. Failing that, you’ll have to sue the builder and get a real estate appraisal expert on board to quantify your damages. It can be done, but it is not an easy process. Give me a ring if you want to talk further.

  2. Pingback: Contributory Negligence on the construction project (law note) « Construction Law in North Carolina

  3. Kelly M. Davis says:

    Melissa,

    Great article and great example for explanation. Here in Texas we usually follow the Joint & Severable rule with exceptions of course.

    You are right that this isn’t always a fun aspect of law to explain to clients if you are on the losing side. On the other hand if you’re on the winning side it’s a nice remedy to help with collection.

    • melissabrumback says:

      Hi Kelly, thanks for stopping by. Yes, for plaintiffs, the joint and several rule can be very helpful if one party cannot be found or has nothing. “You can’t get blood out of stone” my mom used to say. It makes sense: the businesses are in a better position to get insurance, bonds, or otherwise check out who they are throwing their lot in with.

Got a comment? Please share!!!

This site uses Akismet to reduce spam. Learn how your comment data is processed.